A phosphoric acid used as a dairy equipment cleaner was used, check farm stores such as Fleet Farm, or Tractor Supply. There are four bolts to remove from the backing plate, and the electrical connector plug must be detached from the fan tower. That would indicate worn rings. Give your igniter CDI a new lease on life, and enjoy full power spark performance again with new plug wires installed. The following is a copy of the letter they were sent from Rec Sports. Thanks guys, I will steer him clear of the CDI.
Add Your Answer
Signs of a bad CDI?
This can be cured by going to a lower tension clutch spring. This would allow just enough fuel to let the engine run, but run poorly under any sort of load. Good luck and have a nice day. Kawasaki STX-R plug wire replacement service JetSki Solutions, your savior so you don't have to buy new ignition coils just because the plug wires are damaged. Add Your Answer Tips for a great answer: What is a "fouled" spark plug? This is problematic on the mag end, as access is limited, and you have arcing points under the flywheel.
Etec won't starthas spark & fuel
Anonymous Member since June, Another interesting point is the "sparks when you let off the start button" syndrome. The borderline between the fouling and optimum operating regions is called the spark plug self-cleaning temperature. If a sled is out of phase does it not backfire a lot and give problems though? But if you don't, try to thousandths.
This is a huge increase over a non prepped sled. Every sledder needs a pair and Spy has loads of different styles and colours to choose from. Another interesting point is the "sparks when you let off the start button" syndrome. COM Enter keywords or a search phrase below: Track Stud Kit A little more traction never hurt anybody.
4 months ago